|Filter slide cover?
|Page 1 of 1|
|Author:||Erik [ Wed Apr 01, 2009 6:52 pm ]|
|Post subject:||Filter slide cover?|
|I have a 2" Lumicon filter slide, which I really enjoy using. However, it becomes a dew trap for my filters on the more humid nights. I wanted to try and build some sort of cover. Not only for dew protection, but so I could leave the filters permanently installed on the slide, and attached to the scope (my ep case has no room). I tried getting a piece of plexiglass with the intention of making a cover, but I found it difficult to cut curved and hard angles in acrylic sheets without cracking it.
Anyone come up with a better ATM solution. Or is there an aftermarket solution that I'm unaware of? I'd like to avoid anything that weighs much, as I don't want to upset my balance.
|Author:||Square_peg [ Thu Apr 02, 2009 12:00 am ]|
|Post subject:||Re: Filter slide cover?|
Try a router. Or maybe you could design it and have your plexiglass supplier cut it for you.
|Page 1 of 1||All times are UTC-08:00|
|Powered by phpBB® Forum Software © phpBB Limited